Temp It Filling Material


Temp I is a light-curing elastic material purposed for temporary restoration. Suitable for all inlay and onlay type of fillings, it can be used for sealing the implant-screw access or as a block out material.

Available on backorder

We ship products in a matter of hours after successful payment, during the work week*

    SKU: 3279 Category: Tag: Product ID: 3279


    Manipulations with the Temp It filling material are very simple – the material is very easy to apply, as well as remove. It is a very durable and tight marginal seal. Physically it is non-sticky and elastic, with low polymerization shrinkage. Can be used by dentists for deep inlay preparation.

    Available shades are: yellow (tooth), blue


    1. Prepare the cavity – clean and dry
    2. Take the syringe lid off and rotate the extruder clockwise to dispense the proper amount
    3. Apply some Temp It filling material into the cavity, using an appropriate tool like a spatula
    4. Make sure there is as least excess as possible, when contouring the restoration
    5. An increment of 4mm can be cured for 10 to 20 seconds, using a standard curing light, i.e. about 650m/cm2
    6. Check the occlusion and adjust if necessary


    3g x 3 syringes, tips

    Additional information

    Weight 0.050 kg
    Shop Feed
    *up to 48 hours; not applicable to backorders
    *The data submitted in this form will be stored but never given away, shared or sold to a third party.
    Company info Contact USA
    Georock Desing SRL
    Reg. No. 38115792
    Poporului Nr. 36
    900178 Constanta, Romania

    209 E 11th Street #12
    Los Angeles, CA 90015, USA
    Tel (US): +1 (323) 250-7104
    Email: [email protected]